Journal is indexed in following databases:



2022 Journal Impact Factor - 0.6
2022 CiteScore - 1.7



HomePage
 




 


 

ISSN 2083-6473
ISSN 2083-6481 (electronic version)
 

 

 

Editor-in-Chief

Associate Editor
Prof. Tomasz Neumann
 

Published by
TransNav, Faculty of Navigation
Gdynia Maritime University
3, John Paul II Avenue
81-345 Gdynia, POLAND
www http://www.transnav.eu
e-mail transnav@umg.edu.pl
An Influence of Fouling Gathered on the Heat Transfer Surfaces on the Heat Performance Characteristics of the Ship Steam Systems' Heat Exchangers
Times cited (SCOPUS): 1
ABSTRACT: Gathering of fouling on the heat transfer surfaces, both on the water side and the steam side of heat exchangers of the ship steam systems leads usually to the loss of their heat transfer capacities. This loss appears owing to the high value of the fouling heat resistance and is called the thermal degradation process. It is linked to falling the heat flux transported by a heat exchanger and decreasing total efficiency of the heat unit as well as increasing costs of operation and freight costs after all. The loss of thermal power of a heat exchanger does not only depend on the fouling thermal resistance but is also strictly correlated with the thermal quantities of a given heat exchanger, among others its overall heat transfer coefficient values at various operating modes. The paper presents the aforementioned phenomena and results of the author’s own experimental studies, as well.
REFERENCES
Brahim, F., Augustin, W., Bohnet, M.: Numerical Simulation of the Fouling on Structured Heat Transfer Surfaces (Fouling). Heat Exchanger Fouling and Cleaning: Fundamentals and Applications. 121 (2003).
Brodowicz, K.: Teoria wymienników ciepła i masy. PWN, Warszawa (1982).
Butrymowicz, D., Hajduk, T.: Zagadnienia degradacji termicznej wymienników ciepła. Technika Chłodnicza i Klimatyzacyjna. nr 3, 111–117 (2006).
Butrymowicz, D., Trela, M.: Influence of fouling and inert gases on the performance of regenerative feedwater heaters. Archives of Thermodynamics. Vol. 23, no 1–2, 127–140 (2002).
Chenoweth, J.M.: Final Report of the HTRI/TEMA Joint Committee to Review the Fouling Section of the TEMA Standards. null. 11, 1, 73–107 (1990). - doi:10.1080/01457639008939724
Cunningham, J.: The Effect of Use of Noncondensable Gases on Enhanced Surface Condensers. In: Marto, P.J. and Nunn, R.H. (eds.) Power Condenser Heat Transfer Technology. pp. 353–366 Hemisphere Publishing Corporation, Washington (1981).
Dobosiewicz, J.: Wpływ jakości wody zasilającej i kotłowej na trwałość powierzchni ogrzewalnych generatora. Energetyka. 7, 517–521 (2006).
Förster, M., Bohnet, M.: Modification of molecular interactions at the interface crystal/heat transfer surface to minimize heat exchanger fouling. International Journal of Thermal Sciences. 39, 7, 697–708 (2000). - doi:10.1016/S1290-0729(00)00229-5
Górski, Z., Perepeczko, A.: Okrętowe kotły parowe. Akademia Morska Gdynia, Gdynia (2013).
Hajduk, T.: Research of Deposit Accumulated on Heat Exchange Surfaces in the Light of Thermal Degradation of Heat Exchange Aparatus of Steam Power Plants Part I: Study of Real Sediments. Polish Maritime Research. 25, 1(97), 99–107 (2018). - doi:10.2478/pomr-2018-0012
Karabelas, A.J.: Scale formation in tubular heat exchangers—research priorities. International Journal of Thermal Sciences. 41, 7, 682–692 (2002). - doi:10.1016/S1290-0729(02)01363-7
Knudsen, J.G.: Fouling in Heat Exchangers. In: Hewitt, G.F. (ed.) Handbook of heat exchanger design. p. 3.17.1.1-3.17.7-5 Begell House Inc., New York (1992).
Kowalski, A., Krzyżanowski, J.: Teoria okrętowych kotłów parowych. Wyższa Szkoła Morska, Gdynia (1993).
Mizielińska, K., Olszak, J.: Parowe źródła ciepła. Wydawnictwo Naukowo Techniczne, Warszawa (2014).
Mwaba, M.G., Rindt, C.C.M., Vorstman, M. a. G., A. A. Steenhoven, V.: Calcium sulfate deposition on a heated plate and removal characteristics. Proceedings of the 4th international conference on heat exchanger fouling : fundamental approaches and technical solutions, Davos, Switzerland, July 8-13, 2001. 57–63 (2001).
Pudlik, W.: Wymiana i wymienniki ciepła. Politechnika Gdańska, Gdańsk (1988).
Rusowicz, A.: Analiza powstających osadów w rurach skraplacza energetycznego. Presented at the XII Sympozjum Wymiany Ciepła i Masy , Kraków (2004).
Stańda, J.: Woda do kotłów parowych i obiegów chłodzących siłowni cieplnych. Wydawnictwo Naukowo Techniczne, Warszawa (1999).
Stewart, J.: Calculus. Rachunek różniczkowy i całkowy funkcji jednej zmiennej. Wydawnictwo Naukowe PWN, Warszawa (2020).
Szargut, J.: Ekologiczne uwarunkowania energetyki. Energetyka. 1, 378–383 (1993).
Taborek, J.: Effects of Fouling and Related Comments on Marine Condenser Design. In: Marto, P.J. and Nunn, R.H. (eds.) Power Condenser Heat Transfer Technology. pp. 425–430 Hemisphere Publishing Corporation, Washington (1981).
Taylor, J.: Wstęp do analizy błędu pomiarowego. Wydawnictwo Naukowe PWN, Warszawa (2011).
Wiśniewski, S., Wiśniewski, T.S.: Wymiana ciepła. Wydawnictwo Naukowo Techniczne, Warszawa (2000).
Citation note:
Hajduk T.: An Influence of Fouling Gathered on the Heat Transfer Surfaces on the Heat Performance Characteristics of the Ship Steam Systems' Heat Exchangers. TransNav, the International Journal on Marine Navigation and Safety of Sea Transportation, Vol. 15, No. 1, doi:10.12716/1001.15.01.18, pp. 183-188, 2021

File downloaded 194 times








Important: TransNav.eu cookie usage
The TransNav.eu website uses certain cookies. A cookie is a text-only string of information that the TransNav.EU website transfers to the cookie file of the browser on your computer. Cookies allow the TransNav.eu website to perform properly and remember your browsing history. Cookies also help a website to arrange content to match your preferred interests more quickly. Cookies alone cannot be used to identify you.
Akceptuję pliki cookies z tej strony